Capacity of Vehicle batteries (tbc)

Capacity of Vehicle batteries (tbc)

by
Supervisor(s)	Josef.Noll
Due date	2027-05-15
Status	Planned
Problem description:	a) efficient storage in Wh/kg for vehicle batteries b) what are the components/ingredients influencing the storage capacity Batterie: kathode, Anode, "ions" how does the chemistry affect LiIon batteries? What are the effects of Nano-structures for Kathode/Anodes in batteries what is driving the Wh/kg storage capabilities of vehicle batteries? Optimization challenge: price, availability of materials Wh/kg recharge cycles (degradation) max electricity physical: stability, fire, secondary use (value) Applicability: car battery, residential storage (houses), resilience storage, frequency stabilisation, long-term (seasonal?) storage Stena Recycling close to us at Kjeller Test-procedure for quality assessment of a vehicle battery? SDGs - sustainability: seldom earth Discussion on break-through of NaIon batteries MasterThesis_Philip_Rudningen_May2024.pdf Nature_SodiumBatteries_s41560-024-01701-9.pdf
Methods and Tools:	The tools and methods in this thesis are based on A set of scenario, describing the challenges A list of requirements being extracted from the scenarios A description and evaluation of technologies and tools being candidates for solutions A functional architecture/description of the envisaged system An implementation of the core concepts A demonstration of the solution An evaluation of the solution, including a critical review of the descisions taken earlier Conclusions References
Time schedule	The envisaged time schedule (for a long thesis/60 ECTS) is: T0 0 starting month, T0+m denotes the month where the contribution to a certain chapter shalle be finalized T0+2 months: create an initial page describing the scenario T0+3: Provide a list of technologies which you think are necessary for the thesis T0+4: Establish the table of content (TOC) of the envisaged thesis. Each section shall contain 3-10 keywords describing the content of that section T0+7: Provide a draft of section 2 (scenario) and 3 (technologies) T0+10: Establish a draft on what to implement/architecture T0+11: Set-up an implementation, testing and evaluation plan T0+15: Evaluate your solution based on a set of parameters, keep in mind there is no such thing as a free lunch T0+17: Deliver the thesis
Pre-Knowledge	Battery chemistry
Approved	Pending by
Keywords	Battery
Depiction

this page was created by Special:FormEdit/Thesis, and can be edited by Special:FormEdit/Thesis/Capacity of Vehicle batteries (tbc)

This page provides hints on what to include in your master thesis.

TOC

Title page, abstract, ...

1. Introduction, containing: short intro into the area, what is happening

1.1 Motivation, containing: what triggered me to write about what I'm writing about

1.2 Methods, containing: which methods are you using, how do you apply them

2. Scenario, optional chapter for explaining some use cases

2.1 user scenario, (bad name, needs something bedre)

2.2 Requirements/Technological challenges

3. State-of-the art/Analysis of technology, structure your content after hardware/SW (or other domains). Describe which technologies might be used to answer the challenges, and how they can answer the challenges

3.1 technology A

3.2 technology B

4. Implementation

4.1 Architecture, functionality

4.2

5. Evaluation

6. Conclusions

References

Comments

Red line

Your thesis should have a "red line", which is visible throughout the whole thesis. This means you should mention in the beginning of each chapter how the chapter contributes to the "goals of the thesis".

Use of scientific methods

A thesis follows a standard method:

• describe the problem (problemstilling)
• extract the challenges. These challenges should be measurable, e.g. method is too slow to be useful to voice handover.
• Analyse technology with respect to challenges. Don't write & repeat "everything" from a certain technology, concentrate on those parts (e.g. protocols) which are of importance for your problem

References

• Wikipedia is good to use to get an overview on what is happening. But there is not scientific verification of Wikipedia, thus you should use wikipedia only in the introduction of a chapter (if you use text from wikipedia). Use scientific literature for your thesis.
• Scientific library is "at your hand", you can get there directly from UiO: [[How to get access to IEEE, Springer and other scientific literature -> Unik/UiOLibrary]]
• I suggest that references to web pages, e.g. OASIS, W3C standards, are given in a footnote. Only if you find white papers or other .pdf documents on a web page then you refer to them in the reference section.

Evaluation of own work

Perform an evaluation of your own work. Revisit the challenges and discuss in how you fulfilled them. Provide alternative solution and discuss what should be done (or what could have been done).